Digital cameras are machines and can run into problems when you least expect it. This is a reality, although many of us think that the quality and high-end cameras are free of bugs.
Please note that the experience of cameras and wear down with constant use. The end result is a mechanical problem, such as parts of the camera jams or control keys do not work properly. But take heart, there are no quick fixes you can do together to solve cameraBankruptcy.
Issue is not right. This urge to take part, usually a shot goes up and down. It 's a time to allow light to pass through the lens, so that it reaches the sensor to detect a scene and to register. Once the ball is intercepted, then the trigger back down.
If your camera shutter jams, so it goes up and down, as expected, the images appear too bright. Pressing the attack opportunitiesIf the images are underexposed. Possible causes for this problem are faulty timer, the camera is not properly used for a certain time or the tendon could not be aligned.
To resolve this problem, there are steps that you can be sure to be very careful. First, set the manual mode and turn off the digital flash, LCD screen and image stabilization. Next is the trigger to set the minimum speed of about 15 to 30 seconds and try to take a picture. Then, during theThe exhibition, open the battery compartment and close it again. The idea is to disconnect the power when the exposure to open your blind. This step a few times.
Another common problem is the rapid exhaustion of the batteries in cold weather. Low temperatures usually affect battery performance. Alkaline batteries are more prone to this problem than nickel-metal hydride and lithium-ion battery packs. The best thing you can do then is to bring extra batteries if you plan to shootduring the winter season. Be sure to keep warm inside the camera bag or your pocket and change the batteries in the cold if necessary.
Condensation is a third problem with digital cameras. This happens when the unit is in hot spots using a cold or vice versa. When condensation occurs, the lens is foggy in the rule and the internal parts may be affected.
To resolve this problem, you should check your position and avoidextreme conditions digital camera. If you change your position, make sure the camera bag and seal in airtight plastic lenses. Add holding a container of desiccant inside the warm gradually realized. It will therefore be seen that the humidity is based on the bag and not on camera. Have a drying agent, as a form of silica gel to help absorb the possibility of moisture, but they also regularly so that they work fine.
ไม่มีความคิดเห็น:
แสดงความคิดเห็น